St. Catherine's College, Oxford, England
PROCEEDINGS OF THE 9TH SYMPOSIUM HELD IN OXFORD ON MARCH 21 - 22, 1988
N. C. Baines
St. Catherine's College, Oxford, England
Measuring Techniques at the High—Speed Cascade Wind Tunnel of the University of the Federal Armed Forces Munich
The Steam Test Rig at KWIJ and its Cascade Steam Tunnel
H. —G. Hosenfeld
Siemens UB KWIJ, Mülheim, Germany
THE WHITTLE LABORATORY TRANSONIC ANNULAR CASCADE WIND TUNNEL
R. G. Dominy
A NEW RADIAL-INFLOW TURBINE TEST FACILITY
N C Baines and M Lavy
THE INFLUENCE OF TAILBOARDS WITH VARIOUS WALL POROSITY ON TRANSONIC TURBINE CASCADE FLOW
J. M. Henne, H. E. Gallus
PRELIMINARY EXPERIENCE WITH HIGH RESPONSE PRESSURE MEASUREMENTS IN A MULTISTAGE, HIGH SPEED COMPRESSOR
TURBULENCE MEASUREMENTS WITH A HIGH RESPONSE PRESSURE PROBE
G. Ruck
SEMICONDUCTOR WEDGE PROBES FOR UNSTEADY FLOW MEASUREMENTS
W. Elmendorf, G. K. Kauke
Institut für Strahlantriebe und Turboarbeitsmaschinen RWTH Aachen
TRANSONIC CASCADE PERFORMANCE MEASUREMENTS USING A HIGH SPEED PROBE TRAVERSING MECHANISM IN A SHORT DURATION WIND TUNNEL
C. H. Sieverding, T. Arts, M-H. Pasteels
A LASER ANEMOMETRY TECHNIQUE FOR MEASUREMENTS A SINGLE STAGE SUPERSONIC COMPRESSOR
Isabelle Trebinjac, André Vouillarmet
Ecole Centrale de Lyon FRANCE
APPLICATION OF A TO INVESTIGATI ON COPPER VA POUR LASER SHOCK AND BLADE IN A SHOCK TUBE
R.J PARKER, J.B BROWNELL
WET STEAM TURBINES: STEAM TEMPERATURE AND SUBCOOLING MEASUREMENT BY FIBER OPTIC SENSOR
AN INVESTIGATION OF THE SHOCK WAVE STRUCTURE IN A CONDENSING WET STEAM CASCADE
S.A. Skillings
DETECTION OF SEPARATION BUBBLES BY HEATED THIN-FILM SENSORS IN TRANSONIC TURBINE CASCADES
F. Kost, W. Bräunling, E. Schüpferling, R. Göhl
DFVLR - Institute for Experimental Fluid Mechanics, Göttingen
MTU Motoren- und Turbinen-Union München GmbH
Three—Dimensional Endwall Discurbances in the Entrance Region of a Supersonic Cascade
Η. Α. Schreiber
DESIGN FEATURES 0F Α FLΑΤ-ΡLΑΤΕ FOR BOUNDARY LAYER STUDIES
R.M. Watt
THE USE OF WIDE BANDWIDTH HEAT TRANSFER GAUGES TO DIAGNOSE UNSTEADY TURBOMACHINERY FLOWS
M. L. G. Oldfield and R. W. Ainsworth
University of Oxford
Instrumentation Developments for Heat Transfer Measurement under Rotating Conditions
PROBLEMS INVOLVED IN SUBSONIC AND SUPERSONIC PROBES CALIBRATION IN OPEN TUNNELS
S. Cabitza and N. Mandas
A Cold Heat Transfer Tunnel Employing Liquid Crystals for Measuring Full Surface Heat Transfer Coefficients over Turbine Blade Passages
P. T. Ireland, Z. Wang, T. V. Jones, A. R. Byerley
A NEW TRANSONIC PROBE
M. Brunot
Development and Investigation Of Cone—Type Five—Hole Probes for Small Gas Turbines
W - Koschel and P. Pretzsch
AN INVESTIGATION INTO THE EFFECTS OF REYNOLDS NUMBER AND TURBULENCE UPON THE CALIBRATION OF 5-HOLE CONE PROBES
H.P. Hodson and R.G. Dominy
A GENERAL THEORETICAL CONSTRAINT AT M = 1 FOR INTRUSIVE PROBES and SOME TRANSONIC CALIBRATIONS OF SIMPLE STATIC-PRESSURE AND FLOW-DIRECTION PROBES
P.E.Hancock
Change of Flow Conditions due to the Introduction of an Aerodynamic Probe during Calibration.
T. H. Fransson, F. Schaller, K. Schulz